Error ID=0

When launching the ICVERIFY® for Windows® software (version 2.x), some machines encounter an error, usually labeled as "ERROR ID=x" (x is usually 0, but may be some other number).

This happens when certain DLL files were not properly updated during the installation of the ICVERIFY program. We have created a batch file (ERRORID0.BAT) that will remove these files. When you re-run the ICVERIFY software, the correct, updated .DLL files will be installed.

IMPORTANT: This file resolves occurrences of ERROR ID=x that occur only when using the ICVERIFY software and should NOT be considered a fix for any other program.

If you have already tried this, you should try the Download update

INSTRUCTIONS:

IMPORTANT: This file should NOT be run on a Microsoft® Windows® NT or 2000 machine!

1. Insert a blank formatted floppy disk in your floppy drive.
2. Download this bat zip file, and save it to the floppy disk.
3. Extract the .zip file and be sure to save the files to your floppy disk.
4. Remove floppy disk from the drive.
5. Click "Start".
6. Click "Shutdown".
7. Choose "Restart in MS-DOS mode" (System will restart and come to a C:\windows prompt).
8. Reinsert the floppy disk.
9. Type a:\ERRORID0.BAT (or "b:" if that is your floppy drive identifier).
10. You will be prompted to answer "Y" or "N". If this is a Windows 95/98 machine, type "Y".

    At this point, the system will restart and you should get several lines of text flashing by. Do not interrupt it. It will restart your system to Windows.

    You may see several errors about missing files. This is normal.

11. Remove floppy disk from drive.
12. Reinstall the ICVERIFY software.
13. When prompted "If your bank has provided you with an additional diskette labeled Configuration Diskette..." select "NO".

    (Skip Steps 13 & 14 if this is a new installation of the ICVERIFY software).

14. If the ICVERIFY software upgrade Wizard launches, click "Cancel". You will be prompted with a warning; click "Yes".
15. The ICVERIFY Setup Wizard will launch; click "Cancel".
16. Click "Start".
17. Select "Shutdown".
18. Select "Restart" (The system will restart to Windows).
19. Launch the ICVERIFY program.

Should you need to reverse the fix provided by the ERRORID0.BAT file, you can run the included UNDOID0.BAT file

INSTRUCTIONS:

IMPORTANT: This file should NOT be run on a Windows NT machine!

1. Click "Start".
2. Click "Shutdown".
3. Choose "Restart" in MS-DOS mode (System will restart and come to a C:\windows prompt).
4. Reinsert the floppy disk.
5. Type: a:\UNDOID0.BAT (or B: if that is your floppy drive identifier).
6. You will be prompted to answer "Y" or "N". If this is a Windows 95/98 machine, type "Y".

At this point the system will restart, and it will be restored to the condition prior to running the ERRORID0.BAT program.

7. Remove floppy disk from drive

   IMPORTANT: You may NOT be able to run ICVERIFY after running the ERRORID0.BAT file.

Back to ICVERIFY Errors